Faulty Signal
Faulty signal
Diagnostic trouble code (DTC) status ECM-910E Engine control module (ECM), internal fault. Faulty signal
Reading off DTC status ECM-910E
Note! When reading off the DTC status, other stored diagnostic trouble codes (DTCs) and their status will be listed.
- Read off the DTC status. Check the status of the relevant Diagnostic Trouble Code (DTC).
Was the status of the relevant Diagnostic Trouble Code (DTC) displayed as permanent?
Yes - Replacing throttle unit and programming
No - Fault-tracing information
-------------------------------------------------
Replacing throttle unit and programming
The throttle unit has registered an internal fault. Registration has occurred in the engine control module (ECM).
Caution! A new throttle unit is delivered without software. For the throttle unit to function after replacement, the throttle unit must be programmed.
For information about programming and replacing the throttle unit, see the relevant service procedure.
Continue - Fault-tracing information
-------------------------------------------------
Fault-tracing information
The throttle unit has previously registered a fault, but has detected that the fault no longer exists.
Continue - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.
Do you want to view the information again?
Yes - Attempt New Test
No - Fault Found
------------------------
Attempt New Test - ???
FAULT FOUND - Fault Found
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
YES: Repeat Procedure.
NO: Troubleshooting complete for this DTC.
-------------------------------------------------