Signal missing or too low. Intermittent fault

Signal missing or too low. Intermittent fault

Checking the wiring
- Remove relay 2/58.
Check the driver circuit for the relay coil for an intermittent open-circuit as follows: activate the relay driver. Measure the voltage between terminals #1 and #2 on the relay base.
For further information about intermittent open-circuits.

Hint: The voltage between terminals #1 and #2 should be battery voltage.
If the value deviates excessively, check the voltage between terminal #2 and the battery and between terminal #1 and ground. Both should equal battery voltage.
Check for an intermittent open-circuit.
Do not forget to check that the power supply to the control module is OK.

Other information:
- To access the integrated relay / fusebox in the cargo compartment, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.









Was a fault detected?

Yes - Fault-tracing information

No - Checking the control module for short-circuits

-------------------------------------------------

Checking the control module for short-circuits
Measure the resistance between terminal #2 and ground when the relay driver is active.
The resistance should be high when the relay driver is active.
Replace the control module if the resistance is low.

Other information:
- To access the integrated relay / fusebox in the cargo compartment, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing.






Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the wiring

FAULT FOUND - Fault Found

-------------------------------------------------