Pinout Values and Diagnostic Parameters

Signal specification

Connector A, terminals #A1 #A22






All values given below are between the respective terminal in column 1 and terminal #A13 (signal ground).If this is not the case it is indicated in parentheses.

NOTE: It is important to connect the breakout box and check ground terminals before reading off.

U = DC voltage in volts (V)
U[AC] = Alternating current in volts (V)
U[bat] = Battery voltage
f = Frequency in Hertz (Hz)
U[low] = Voltage approximately 0 V %
duty = Duty cycle (pulse ratio) as a percentage (%)
t = Time in milliseconds (ms)
















Connector B, terminals #B1 #B30







All values given below are between the respective terminal in column 1 and terminal #A13 (signal ground).If this is not the case it is indicated in parentheses.

NOTE: It is important to connect the breakout box and check ground terminals before reading off.

U = DC voltage in volts (V)
U[AC] = Alternating current in volts (V)
U[bat] = Battery voltage
f = Frequency in Hertz (Hz)
U[low] = Voltage approximately 0 V %
duty = Duty cycle (pulse ratio) as a percentage (%)
t = Time in milliseconds (ms)