Faulty Signal

Faulty signal

Checking the connector




- Ignition off.
Check the engine speed (RPM) sensor and camshaft position (CMP) sensor connectors. Check for contact resistance. Check for oxidation.
Remedy as necessary.

Other information
- Location of components Locations
- Checking wiring and terminals Checking Wiring And Terminals

Has the fault been found and remedied?

Yes - Fault Found

No - Checking components

-------------------------------------------------

Checking components
Check that the engine speed (RPM) sensor is securely installed in the correct position.
Check carrier plate / flywheel for damage and scratches through the engine speed (RPM) sensor hole.
Try a new engine speed (RPM) sensor if no fault has been detected on the carrier plate / flywheel.

Hint: The diagnostic trouble code (DTC) may be caused by a damaged camshaft position sensor.

Other information
- Location of components Locations
- Location of components Locations
Remedy as necessary.


Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the connector

FAULT FOUND - DONE

DONE - DONE

-------------------------------------------------