Too Little Roar

Too little roar

Checking components and connectors
Check the connector. Check for contact resistance and oxidation.
Check that the knock sensor (KS) is securely installed.
If there is no contact resistance or oxidation in the connector, try a new knock sensor (KS).
Remedy as necessary.

Other information
- Signal specification Signal Description / Specification
- Knock sensor (KS), replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals


Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking components and connectors

FAULT FOUND - DONE

-------------------------------------------------