Procedures

Replacing Camshaft Position (CMP) Sensor

Remove:
- relay cover bracket
- connector camshaft position sensor from bracket.

Removing camshaft position (CMP) sensor







- Remove the protective sleeve out of the clamp and open the outer cable protection
- Route the wiring out the protector
- Clean surrounding around sensor
- Remove bolt and move camshaft position (CMP) sensor by turning and take sensor out
- Take cable out clamp.

NOTE: Note the route of the cable and take it out of the clamp.

Installing camshaft position (CMP) sensor







- Place a new O-ring on the sensor
- Clean housing
- Route the cable via the protective tube and connect the connector at the bracket
- Close the protective tube and install the tube in the clamps
- Place the sensor and tighten the bolt. Tightening torque 10 Nm
- Secure cable in the clamp.

Install
Connector bracket cover.

Start engine. Read any diagnostic trouble codes (DTCs).