Engine Speed Sensor: Service and Repair

Replacing Engine Speed (RPM) Sensor

Remove
- Air cleaner (ACL)
- Engine cover.

Removing engine speed (RPM) sensor from engine







- Clean area around sensor
- Remove bolt and lift out sensor
- Release cable guide and remove engine speed (RPM) sensor wiring
- Pull cable upwards.

Removing engine speed (RPM) sensor







- Remove the two hose clamps from protective tube
- Carefully pull out the sensor
- Remove the relay cover and cut the tie strap
- Disconnect connector and lift off engine speed (RPM) sensor.

Installing engine speed (RPM) sensor
- Connect connector
- Clamp cable to the bracket with tie strap
- Route the cable via the protective tube to the cylinder head
- Close protective tube with two hose
- Reinstall relay cover.

Installing engine speed (RPM) sensor on the engine







- Route the cable downwards
- Secure and tighten the cable guide
- Clean the sensor mounting surface
- Install engine speed (RPM) sensor.
- Tightening torque 10 Nm.

Reconnect
- Air cleaner (ACL)
- Battery.

Start engine. Read any diagnostic trouble codes (DTCs).