Signal Too High

Signal too high

Checking the wiring and component
Check the cable between the ignition's #50 and starter motor relay's #2 as well as between starter motor relay's #2 and the control module's #B23 for intermittent short-circuiting to voltage.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box
- Engine control module (ECM), replacing Service and Repair
- Signal specification Signal Description / Specification
- Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults






Continue - Verification

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the wiring and component

FAULT FOUND - Fault Found

DONE - DONE

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reconnect connectors, reinstall components
- Operate the starter motor.
- Read off the signal from ignition switch.
It should be ON.





Is the signal ON?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------