Verification

Verification







HINT: After carrying out the repair, check that the fault has been remedied.

- Ignition off
- Reconnect the connectors, reinstall components etc.
- Start the engine
- Ignition off
- Ignition on
- Read off the movement of the accelerator pedal by carefully depressing and releasing the accelerator pedal (AP).

Check that the value changes with accelerator pedal movement. The value must be between approximately 0.4 V when the accelerator pedal (AP) is unaffected and approximately 4 V when the accelerator pedal (AP) is fully depressed.

The fault has been remedied if the values are OK.

Are these values OK?

YES: Refer to Trouble Code Descriptions. Diagnostic Trouble Code Descriptions
NO: Continue with Test (See "Fault-Tracing Information - Permanent Fault"). Fault-Tracing Information - Permanent Fault