Open-Circuit

Open-circuit

Checking for intermittent faults




- Ignition on
- Read off the system voltage.
Voltage should be approximately battery voltage.





Is the system voltage OK?

Yes - DONE

No - Checking the wiring and component

-------------------------------------------------

Checking the wiring and component
Check the circuit between engine control module (ECM) terminal #B11 and the battery. Check for an open-circuit. See the relevant applicable wiring diagram.

Other information
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box
- To access the control module, see
- For information about signals see Signal specification Signal Description / Specification
- Checking wiring and terminals Checking Wiring And Terminals.






Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reconnect connectors, reinstall components
- Ignition on.
- Read off system voltage.
Voltage should be approximately battery voltage.





Is the system voltage OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking for intermittent faults

-------------------------------------------------