Removing Tailgate Assembly

Tailgate

Removing The Tailgate Assembly







- If necessary replace the components.
- Disconnect the connector for the tail lamp.
- Pull the cable harness up through the rear fender.
- Lift up the lock for the gas strut. Pull the gas strut from the ball joint.
- Remove the screws which secure the hinge to the trunk lid. Remove the trunk lid.

Installing The Tailgate Assembly
- Install the tailgate. Finger tighten the screws.
- Lubricate the ball joints. Press the gas struts and retaining clip into place. Check that the gas strut is locked.
- Use a piece of string to feed the cable harness in.
- Connect the connectors for the tail lamp.
- If necessary, install the components for the tailgate.
- Carefully close the tailgate. Check the alignment.
- Tighten the screws. Tighten to 21 Nm.
- If necessary, adjust the tailgate.