Connecting The Breakout Box. Fenix 5.1

Connecting the breakout box. FENIX 5.1

Special tools:
951 1358 Adaptor 55-pin ABS Fenix 5.1 S40,V40 951 1358 Adaptor 55-Pin ABS Fenix 5.1
981 3190 Replaced by 9511428 981 3190 Replaced by 951 1428

Connecting the breakout box to the connector at the engine control module (ECM)




- Ignition off
- Remove the security strap around the engine control module (ECM). Remove the control module from the bracket. See
- Disconnect the engine control module (ECM)
- Disconnect the control module
- To avoid interfering with the pedals, the cable harness with the control module connector must be pulled over to the right of the center console (left-hand drive) or to the left of the center console (right-hand drive). The connector must be put on the floor
- Check that the male and female terminals in the control module and the control module connector are intact and secure. Check that the wiring to the female terminals is properly secured to the pins
- In particular, check the terminal pins relevant to the diagnostic trouble code (DTC) / symptom
- Connect adapter 951 1358 Adaptor 55-pin ABS Fenix 5.1 S40,V40 951 1358 Adaptor 55-Pin ABS Fenix 5.1 to the engine control module (ECM) connector. Connect breakout box 981 3190 Replaced by 9511428 981 3190 Replaced by 951 1428 to the adapter.