Too Much Roar

Too much roar

Checking components and connectors
Check the connector. Check for contact resistance and oxidation.
If there is no contact resistance or oxidation in the connector, try a new knock sensor (KS).
Remedy as necessary.

Other information
- To access or replace the knock sensor (KS), see Knock sensor (KS), replacing Service and Repair
- For information about signals see Signal specification Signal Description / Specification
- Checking wiring and terminals Checking Wiring And Terminals.






Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking components and connectors

FAULT FOUND - DONE

-------------------------------------------------