Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information ECM-930C

Condition




The engine control module (ECM) checks the signal from the clutch pedal sensor.
The diagnostic trouble code (DTC) is stored if the engine control module (ECM) registers a fault in the signal from the clutch pedal position sensor.
The diagnostic trouble code (DTC) can be diagnosed when the ignition is switched on.

Substitute value
- Cruise control is disengaged when the fault is active.

Possible source

Signal too high
- Short-circuit to voltage in the signal cables
- Open-circuit in the signal cables
- Damaged clutch pedal sensor.

Signal too low
- Short-circuit to ground in the signal cables
- Damaged clutch pedal sensor.

Faulty signal
- Contact resistance in the connectors
- The clutch pedal sensor is out of position
- Damaged clutch pedal sensor.

Fault symptom[s]
- Cruise control does not function at all.