Signal Too High
Signal too high
Diagnostic trouble code (DTC) status ECM-1300 Intake Air Temperature (IAT) Sensor. Signal too high
Reading off diagnostic trouble code (DTC) status ECM-1300
Note! When reading off the diagnostic trouble code (DTC) status, other stored diagnostic trouble codes (DTCs) and their status will be listed.
- Read off the diagnostic trouble code (DTC) status. Check the status of the relevant diagnostic trouble code (DTC).
Was the status of the relevant diagnostic trouble code (DTC) permanent?
Yes - Checking the wiring and component
No - Intermittent fault
-------------------------------------------------
Intermittent fault
Signal too high. Intermittent fault
Checking wiring and connectors
Check signal cable between control module #A22 (#A22) and mass air flow (MAF) sensor terminal 2 for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Other information:
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box
- To access the control module, see
- To access/replace the Mass Air Flow (MAF) sensor, see
- For information about signals, see Signal specification Signal Description / Specification.
Continue - Fault-tracing information
------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Fault Found
------------------------
Attempt New Test - Checking wiring and connectors
DONE - DONE
FAULT FOUND - DONE
-------------------------------------------------
DONE - DONE
-------------------------------------------------
Checking the wiring and component
Check the signal cable between control module connector terminal #A22 (#A22) and mass air flow (MAF) sensor terminal 2. Check for a short-circuit to supply voltage. See Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box
- To access or replace the control module, see
- To access and replace the mass air flow (MAF) sensor, see
- For information about signals see Signal specification Signal Description / Specification.
Continue - Verification
-------------------------------------------------
Verification
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off
- Reconnect the connectors, reinstall components etc.
- Start the engine and let it run at idle speed
- Read off the mass air flow (MAF) sensor signal.
The signal from the mass air flow (MAF) sensor must be approximately 1.35 V at idle speed with an engine at operating temperature not under any load.
Is the mass air flow (MAF) sensor signal OK?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFICATION FAILED - Fault-tracing information
VERIFIED - Fault Found
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - FAULT-TRACING FAILED
No - Attempt New Test
------------------------
FAULT-TRACING FAILED - FAULT-TRACING FAILED
Attempt New Test - Diagnostic trouble code (DTC) status ECM-1300 Intake Air Temperature (IAT) Sensor. Signal too high
-------------------------------------------------