Windshield Washer Reservoir: Service and Repair

Windshield washer fluid reservoir, replacing

Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work
Detach Casing bumper front, replacing Service and Repair on the right-hand side.

Location of components




1. Windshield washer motor
2. Rear windshield washer motor
3. Headlamp washer motor, high-pressure
4. Level sensor.

Removal




Remove the screw for the fuel filler pipe.
Pull up the fuel filler pipe.
Detach the washer hoses at the washer motors (x3). Mark up the hoses. Drain or plug the reservoir.
Disconnect the connectors.
Remove the screws.
Push the bumper cover to one side and lift down the reservoir.

Installation
Push the bumper cover to one side and position the reservoir.
Install the screws.
Align the air hose. Install the 3 washer hoses according to the markings.
Connect the connectors.
Tighten the screws.
Press the filler pipe into place.
Install the screw and tighten.

Finishing work
Install Casing bumper front, replacing Service and Repair.
Fill with windshield washer fluid.
Test the function.