Inflatable Curtain
Inflatable curtain
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.
Preparatory work
Removing battery cable and installation of decal
Ignition off.
Disconnect the battery negative cable. See: Battery Disconnecting
Warning! For information about the handling and storage of pyrotechnical SRS units, see: Handling non-deployed pyrotechnical part Handling Non-Deployed Pyrotechnical Part
Note! Replace the decals for the safety equipment. See: Positioning safety labels (North America) or: Positioning safety labels (rest of the world).
Warning! Never use an ohmmeter or other live measuring measuring instrument to measure on a disconnected, non-deployed pyrotechnical SRS unit. There is a risk of the seatbelt tensioner deploying.
Warning! A pyrotechnical SRS unit must never be dismantled, repaired or moved to another vehicle.
Removal
Removing inflatable curtain (IC)
Remove:
- the headlining as described in Headlining with sun roof Service and Repair Headlining with sun roof Service and Repair Headlining with sun roof Service and Repair
- press clip (1).
Unhook the hook.
Remove:
- carrier clips, 4 per side, from the body acc. to: Support clips inflatable curtain (IC) Support Clips Inflatable Curtain (IC)
- the front upper screw
- the rear screws by the gas generator.
Pull forward the inflatable curtain slightly (1).
Loosen the connector (2) for the igniter cable.
Lift out the inflatable curtain.
Installation
Note! For tightening torques, see Specifications. [1][2]Body and Frame
Installing inflatable curtain (IC)
Lift in the inflatable curtain.
Press the carrier clips, 4 pcs., into place.
Install:
- the rear screws, 2 pcs. M6. Tighten
- the front upper screw, 1 pc. M6. Tighten.
Hook on the front hook.
Install the press clip.
Note! Fold the front part of the inflatable curtain inside the 3 clips in the front edge.
Install the headlining. See: Headlining with sun roof Service and Repair Headlining with sun roof Service and Repair Headlining with sun roof Service and Repair.
Finishing
Final check
Fit the battery's negative cable in accordance with:.
Carry out an inspection as described in Supplementary restraint system (SRS), inspection Component Tests and General Diagnostics.