Seal Ring For Crown Wheel Shaft of Bevel Gear, Replacing
Seal ring for crown wheel shaft of bevel gear, replacingMarking the position of the set nut
Mark the position of the set nut in relation to the housing with a chalk line.
Measure and note the height between the nut and the housing. Remove the screw and catch of the nut.
Removing the set nut
Remove the set nut using 999 7178.
Removing the seal ring
Tap out the seal ring.
Use a screwdriver.
Installing the seal ring
Install the set nut seal ring.
Lubricate the seal lip with wheel bearing grease.
Use 999 7191. Tap in the seal until the face of the drift touches the nut.
Insert a new O-ring on the nut. Lubricate the O-ring and threads with wheel bearing grease.
Installing the set nut
Install the set nut.
Use 999 7178. Turn the propeller shaft while the nut is tightened to the position measured previously.
Checking the marking
Check that the markings align exactly.
Check the height following Marking the position of the set nut. Install the catch. Tighten the screw following Tightening torque. Check the oil level in the bevel gear following Bevel gear oil level, check
Note: For drive shaft installation, see Axle Shaft Assembly; Service and Repair.