Trim Molding

Trim molding

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the front trim molding





Remove:
- the front trim molding.




- any tape residue.

Removing the rear trim molding





Remove:
- the rear trim molding.




- any tape residue.

Installation

Installing the front and rear trim moldings

Note! Ensure that the vehicle is at least at room temperature (above 20 °C).

Wash the area for the molding using a mixture of 50% isopropanol and 50% water.
Wipe dry using a clean lint-free cloth.
Remove the backing from the tape.
Locate the locating pins for the molding in the holes.
Press down along the entire length of the molding to ensure the tape is in contact with the door.

Note! To ensure optimal adhesion, do not wash the car for 72 hours.