Signal Too Low
Signal too low
Status check
Reading off the status of the diagnostic trouble code (DTC)
Engine control module (ECM)
Reading off the status of the diagnostic trouble code (DTC):
Note! When reading off the DTC status, other stored diagnostic trouble codes (DTCs) and their status will also be listed.
- Start the engine. Let it idle for at least 15 seconds.
- Read off the diagnostic trouble code (DTC) status. Check the status of the relevant diagnostic trouble code (DTC).
Was the status of the relevant diagnostic trouble code (DTC) permanent?
Yes - PERMANENT
No - INTERMITTENT
------------------------
PERMANENT - Checking the wiring and component
INTERMITTENT - Intermittent fault
-------------------------------------------------
Checking the wiring and component
Check the cable between control module terminal #A46 and knock sensor (KS) terminal 1. Check for a short-circuit to ground.
Check the cable between control module terminal #A64 and knock sensor (KS) terminal 2. Check for a short-circuit to ground.
Remedy as necessary.
Other information:
- To localize the knock sensor (KS), see
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box
- For information about signals, see Signal specification Signal Description / Specification
- Checking wiring and terminals Checking Wiring And Terminals.
Was a fault found in the wiring?
Yes - Verification
No - Replacing the component
-------------------------------------------------
Replacing the component
Try a new knock sensor (KS) according to Knock sensor (KS), replacing Service and Repair.
Continue - Verification
-------------------------------------------------
Intermittent fault
The control module has previously registered a fault. The fault is now no longer present.
Continue - Fault-tracing information
-------------------------------------------------
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off.
- Reconnect connectors, reinstall components
- Start the engine and rev it once (above 1000 rpm).
- Read off the Diagnostic trouble code (DTC) status. Check the status of the relevant Diagnostic Trouble Code (DTC).
Was the status of the relevant Diagnostic Trouble Code (DTC) displayed as intermittent?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFIED - Fault Found
VERIFICATION FAILED - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - FAULT-TRACING FAILED
No - Attempt New Test
------------------------
Attempt New Test - Status check
FAULT-TRACING FAILED - FAULT-TRACING FAILED
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Fault Found
------------------------
Attempt New Test - Status check
FAULT FOUND - DONE
DONE - DONE
-------------------------------------------------