Fault-Tracing

Fault tracing DEM-168914

Checking the connectors and leads








- Ignition off
- Check connector A with respect to contact resistance and oxidation.
- Check for damage to the leads to connector A.
- Reinstall the connectors, components etc.

Hint: Test drive the car according to the instructions given in the link below.

Remedy as necessary.

Other information:
- Signal specification
- Test driving Active on Demand Coupling, automatic transmission, TF-80SC AWD, AW50/51 AWD
- Checking wiring and terminals Checking Wiring and Terminals

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
As appropriate test drive the car to verify that the function is OK.

Is the function OK?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the connectors and leads

-------------------------------------------------