Signal Too High

Signal too high

Checking the status




- Ignition on.
Activate air conditioning (A/C) relay.
Check that the air conditioning (A/C) relay clicks when activated. The fault is permanent if the relay does not click when activated. The fault is intermittent if the relay clicks.






Continue - Checking the components and wiring

-------------------------------------------------

Checking the components and wiring
Check the signal cable between engine control module (ECM) terminal #B10 (#C10) and air conditioning (A/C) relay connector terminal #2. Check for a short-circuit to supply voltage.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting The Breakout Box, Engine Control Module (ECM)
- For further information about the fuses and relays, see the Wiring Diagram
- Checking wiring and terminals Checking Wiring and Terminals










Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Activate air conditioning (A/C) relay.
Check that the air conditioning (A/C) relay clicks when activated.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the status

-------------------------------------------------