Fault-Tracing

Fault-tracing

Information
If any of the following diagnostic trouble codes are stored, CEM-DE01, CEM-4C01, CEM-4C02, ECM-0117 or ECM-0118, fault-trace according to the relevant fault-tracing information.

Are any of the diagnostic trouble codes (DTCs) above stored?

Yes - DONE

No - Fault-tracing

-------------------------------------------------

Fault-tracing
Check components. Check for an open-circuit, contact resistance and oxidation.

Other information
- Connecting the breakout box Connecting The Breakout Box, Central Electronic Module (CEM)


Continue - Verification

-------------------------------------------------

Verification









Hint: After carrying out the repair, check that the fault has been remedied.

- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
Check that the relevant diagnostic trouble code (DTC) has switched status from permanent to intermittent fault. Carry this out by clicking UPDATE under the DIAGNOSTIC/COMPONENTS tab. Then find the diagnostic trouble code (DTC) in the list under the DIAGNOSTICS/DIAGNOSTIC TROUBLE CODE (DTC) tab.

Is the status of the diagnostic trouble code (DTC) intermittent?

Yes - Fault Found

No - Information

-------------------------------------------------

Information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Information

-------------------------------------------------