Faulty Signal

Faulty signal

Checking the camshaft position (CMP) sensor and rotor
Check the connector for the camshaft position (CMP) sensor. Check for contact resistance and oxidation.
Check the rotor on the camshaft for damage. Check through the camshaft position sensor hole.
Check that the camshaft position (CMP) sensor is securely installed in the correct position.
Check that the camshafts are set correctly.
Check the ground lead between engine control module (ECM) terminal #A65 (#A65) and camshaft position (CMP) sensor 3. Check for an open-circuit.
Remedy as necessary.

Other information
- Signal specification Signal Description / Specification
- Camshaft seal/variable valve timing (VVT) unit, replacing Camshaft Seal/Variable Valve Timing (VVT) Unit, Replacing
- Checking wiring and terminals Checking Wiring And Terminals






Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - Fault Found

Attempt New Test - Checking the camshaft position (CMP) sensor and rotor

-------------------------------------------------