Mobility Connection Package [3 of 5]

Sections 21-31 apply to cars with loudspeaker grilles




- Remove the ventilation outlet by carefully inserting special tool 9995919 between the ribs and carefully pulling up the four catches on the lower edge. Carefully pry using a weatherstrip tool.





- Unplug the connector for the warning flashers and move the unit aside.





- Remove the template from the kit. Cut around the outer lines.





- Tape the template to the loudspeaker grille.


Illustrations A and B




- Cover the opening to the air ducts with paper to avoid chips filling into these.
- Spread out a piece of paper inside the dashboard to catch the swarf. Drill square to the loudspeaker grille where the holes are to be positioned.
- Choose LHD or RHD on the drilling template and carefully predrill the holes according to the template using a -3 mm (1/8") drill bit. Continue to drill through the console to the loudspeaker located 15 mm (19/32") behind the grille.
- Remove the template.






Illustrations A and B




- Remove the loudspeaker grille as follows: insert the tool, P/N 9995919, into the joint between the loudspeaker grille and the dashboard approximately as illustrated, until it engages.
- Twist the tool 90° so that the bent section engages with the underneath of the loudspeaker grille.




- Pull upwards until the loudspeaker grille detaches. The loudspeaker grille is securely fastened by four clips. Move the tool closer to the clip to facilitate removal.

Note! Do not damage the dashboard.

- Lift out the loudspeaker grille.





- Drill the three holes for the cradle's feet using a step drill -14 mm (9/16").





- Take the step drill and drill out the hole for the connection in the holder using a -28 mm (1 7/64") drill bit.





- Tape a piece cloth over the loudspeaker.
- Drill the corresponding hole in the loudspeaker console using a -25 mm (1") hole saw.





- Drill the holes for the cradle's stud screws using a -7 (9/32") mm drill bit.
- Remove the cloth.


Illustrations A and B




- Take three nuts, washer and the cradle out of the kit and secure to the loudspeaker grille.
- Tighten the cradle.