Shorted
Shorted
Checking the function
The LEDs should flash three times whenever the Blind Spot Indication System (BLIS) is activated.
Check the function of the LEDs by starting the engine.
Did the LED flash three times?
Yes - Fault-tracing information
No - Checking the wiring
-------------------------------------------------
Checking the wiring
- Ignition off.
Check the communication cable between the Driver door module (DDM)/Passenger door module (PDM) terminal #B4 (#24) and the left/right camera control module (LCM/RCM). Check for a short-circuit to ground.
Check the communication cable between the Driver door module (DDM)/Passenger door module (PDM) terminal #B4 (#24) and the left/right camera control module (LCM/RCM). Check for a short-circuit to supply voltage.
Remedy as necessary.
Other information
- Signal specification Signal Description, Driver's Door Module / Passenger Door Module (DDM/PDM)
- Checking wiring and terminals Checking Wiring and Terminals
- Rear view mirror external Rear View Mirror External
Continue - Verification
-------------------------------------------------
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
Did the LED flash three times?
Yes - Fault Found
No - Information
-------------------------------------------------
Information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit Fault-Tracing
No - Attempt New Test
------------------------
Attempt New Test - Checking the wiring
-------------------------------------------------
Fault-tracing information
The Driver door module (DDM)/Passenger door module (PDM) has previously registered a fault but the fault no longer occurs. The diagnostic trouble code (DTC) was probably caused by an intermittent fault. If the diagnostic trouble code (DTC) does not recur no further corrective action is required. The fault is evaluated depending on how it occurs.
Do you want to exit fault-tracing?
Yes - DONE
No - Checking the wiring
-------------------------------------------------