Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information ECM-5200

Condition
The diagnostic trouble code (DTC) is stored if the engine control module (ECM) registers engine speed (RPM) above approximately 600 rpm, speed 0 km/h, without the ignition key being in position 3 and it is interpreted as a fault (low signal).
It is interpreted as a fault and the diagnostic trouble code (DTC) is stored if the engine control module (ECM) registers the ignition key in position 3 while driving.

Substitute value
- None.

Possible source

Signal too high
- Short-circuit to supply voltage in the signal cable from the ignition switch.

Signal too low
- Short-circuit to ground in the signal cable from the ignition switch
- Open-circuit in the signal cable from the ignition switch.

Fault symptom[s]
- None.