Control System, Replacing

Control system, replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the cable harness
Remove the cable harness from the control system. See: Cable harness, control system, gearbox, replacing, B8444S, TF-80SC AWD Cable Harness, Control System, Gearbox, Replacing.





Note! Protect the cable harness by taping it to the outside of the transmission.














Installation

Note! For tightening torques, see: Tightening Torque





Caution! Ensure that the cable harness is not trapped when the control system is positioned.




Lightly tighten.




Use new screws and a new gasket.
Lightly tighten.




Tighten alternately, M6.

Installing the cable harness
Install the cable harness for the control system. See: Cable harness, control system, gearbox, replacing, B8444S, TF-80SC AWD Cable Harness, Control System, Gearbox, Replacing.