Faulty Signal

Faulty signal

Checking the connectors and hose connector
Check the hose connectors on the intake manifold for damage and leakage.
Check the connector and terminals on the pressure sensor. Check for contact resistance. Check for oxidation.
Remedy as necessary.

Other information
- Manifold absolute pressure (MAP) sensor Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals














Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Read off the signal from the manifold absolute pressure (MAP) sensor.
Check that the signal is within its permitted range.

Hint: The normal value (atmospheric pressure at sea level) is approximately 3.6 V at ignition on (open throttle).









Is the signal within its permitted range?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the connectors and hose connector

-------------------------------------------------