Faulty Signal

Faulty signal

Checking components

Caution! Do not apply rust solvent spray or grease to the heated oxygen sensor (HO2S) connector.

Check the exhaust system for air leakage.
Try a new heated oxygen sensor (HO2S) if the above fault-tracing does not remedy the fault.
Remedy as necessary.

Other information
- Air leakage exhaust system, check Air Leakage Exhaust System, Check
- Oxygen sensor (Catalyst monitor sensor) Oxygen Sensor (Catalyst Monitor Sensor)














Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.

- Test drive the car and perform a TRIP schedule, see: Verifying repairs Verifying Repairs
- Connect VCT2000 to the data link connector (DLC) without switching off the engine.

Note! If the engine is switched off, the stored fault status will be erased and the test drive will have to be repeated.

Read off the diagnostic status and the fault status for the diagnostic trouble code (DTC).
Check that the diagnostic is "Completed" and that the fault status is "No fault detected". The function is faulty if the fault status is "Fault found".





Is the status of the fault "No fault detected"?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking components

-------------------------------------------------