Combined Instrument Panel, R-Design

Combined instrument panel, R-design

























Combined instrument panel, R-design




- Turn the ignition switch to position 0.

Note! Wait at least three minutes before unplugging the connectors or removing other electrical equipment.




- Adjust the steering wheel to the outermost and lowermost position.
- Remove the two screws at the upper edge of the surround for the combined instrument panel.
- Remove the surround.




- Remove the two screws at the sides of the instrument panel.
- Raise it slightly and unhook it from the holder on the inside of the instrument panel.
- Lift the instrument panel out and disconnect the connector.

Note! Do not damage the instrument panel. The glass is easily scratched.

- Place the instrument panel to one side.




- Take the new instrument panel and connect the connector.
- Insert it in position and hook it onto the holder on the inside.
- Tighten using the two screws.








- Download software for the relevant vehicle type in accordance with the service information in VIDA.