Fault-Tracing

Fault-tracing

Checking the component




- Ignition off.
Check that the internal reserve battery for Volvo On Call is correctly connected.
Check the connector.
Remedy as necessary.

Other information:
- Location of components Phone Module (PHM)
- Battery Volvo On Call Service and Repair
- Phone Module (PHM) Phone Module (PHM) Phone Module (PHM) Phone Module (PHM)

Continue - Verification

-------------------------------------------------

Verification




Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
So that the DTCs test can run correctly, the following sequence must be gone through.
- Drive the vehicle out of the workshop and allow the vehicle to stand a while with the engine running, so that the Phone module (PHM) has time to receive a GPS position.
- Drive the vehicle back into the workshop.
Note! Do not remove the remote key from the start control module (SCU).

- Click the VCT2000 symbol and follow the instructions there.
Check that the diagnostic trouble code has disappeared or changed status to intermittent.





Is the carphone working?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test


-------------------------------------------------