Calibration Fault

Calibration fault

Calibrating the component
- Ignition on
- Light switch in position 2.
Check that the position sensors are correctly installed.
Ensure that the car is unladen and is on a flat surface.
To program the gas discharge lamp module (GDL) with vehicle parameters and to calibrate the position sensor, see Calibration of position sensor, GDL lamps Testing and Inspection.

Other information:
- Connecting the breakout box Connecting The Breakout Box, Central Electronic Module (CEM)
- Position sensor rear, headlamp Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals





Select Continue.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Light switch in position 2.
Switch between high and low beam.
Check that the function is OK.

Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Calibrating the component

-------------------------------------------------