Faulty Position
Faulty position
Checking the component and wiring
- Ignition off
- Light switch in position 0
- Disconnect connector A from the right-hand gas discharge lamp module (GDL).
Check the connectors for contact resistance and oxidation. Check for damage carefully.
Remedy as necessary.
Other information:
- Connecting the breakout box Connecting The Breakout Box, Central Electronic Module (CEM)
- Location of components Component Location, Central Electronic Module (CEM)
- Checking wiring and terminals Checking Wiring And Terminals Checking wiring and terminals Checking Wiring And Terminals
Was a fault detected?
Yes - Verification
No - Checking the component
-------------------------------------------------
Checking the component
Check that the right-hand gas discharge lamp module (GDL) has not been installed on the left-hand side.
If a new gas discharge lamp module (GDL) has been installed, the vehicle information must be programmed.
To program the gas discharge lamp module (GDL) with vehicle parameters and to calibrate the position sensor, see Calibration of position sensor, GDL lamps Testing and Inspection.
Remedy as necessary.
Other information:
- Connecting the breakout box Connecting The Breakout Box, Central Electronic Module (CEM)
- Location of components Component Location, Central Electronic Module (CEM)
- Checking wiring and terminals Checking Wiring And Terminals
Select Continue.
Continue - Verification
-------------------------------------------------
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Light switch in position 2.
Switch between high and low beam.
Check that the function is OK.
Is the function OK?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFIED - FAULT FOUND
VERIFICATION FAILED - Fault-tracing information
-------------------------------------------------
Fault-tracing information
FAULT-TRACING FAILED - FAULT-TRACING FAILED
Attempt New Test - Checking the component and wiring
-------------------------------------------------