Calibration Fault

Calibration fault

Calibrating the component




- Ignition on
- Light switch in position 2.
Check that the position sensors are correctly installed.
Ensure that the car is unladen and is on a flat surface.
Calibration of position sensor, GDL lamps Testing and Inspection

Other information:
- Connecting the breakout box Connecting The Breakout Box, Central Electronic Module (CEM)
- Position sensor rear, headlamp Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals





Select Continue.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Light switch in position 2.
Switch between high and low beam.
Check that the function is OK.

Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Calibrating the component

-------------------------------------------------