Signal Too High

Signal too high

Checking the status




- Start the engine.
Check whether the fault is permanent or intermittent by reading off the signal from the mass air flow (MAF) sensor.
Check that the signal is between 0.5 - 4.5 V.
The fault is permanent if the signal is incorrect. The fault is intermittent if the signal is correct.









Continue - Checking the component and wiring

-------------------------------------------------

Checking the component and wiring
Check the cable between engine control module (ECM) terminal #A70 (#B10) and mass air flow (MAF) sensor terminal #3. Check for a short-circuit to supply voltage.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting The Breakout Box, Engine Control Module (ECM)
- Signal specification Signal Specification, Engine Control Module (ECM)
- Mass air flow (MAF) sensor Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals













Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Read off the signal from the mass air flow (MAF) sensor.
Check that the signal is between 0.5 - 4.5 V.









Is the signal within its permitted range?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the status

-------------------------------------------------