Signal Too High

Signal too high

Checking the status




- Ignition on.
Check whether the fault is permanent or intermittent. Read off the diagnostic trouble code (DTC) fault status when the diagnostic status is "Completed".
The fault is permanent if the fault status is "Fault found". The fault is intermittent if the fault status is "No fault detected".









Continue - Checking the component and wiring

-------------------------------------------------

Checking the component and wiring
Check the cable between engine control module (ECM) terminal #A53 (#A53) and evaporative emission system (EVAP) valve terminal #2. Check for a short-circuit to supply voltage.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting The Breakout Box, Engine Control Module (ECM)
- Location of components, engine compartment Locations
- Checking wiring and terminals Checking Wiring And Terminals













Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.

- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Read off the diagnostic status and the fault status for the diagnostic trouble code (DTC).
Check that the diagnostic is "Completed" and that the fault status is "No fault detected". The function is faulty if the fault status is "Fault found".









Is the fault status "No fault detected"?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the status

-------------------------------------------------