Signal Too Low

Signal too low

Checking the component and wiring

Hint: The diagnostic trouble code (DTC) for this fault can be stored in the central electronic module (CEM). Reading diagnostic trouble codes (DTCs) in the central electronic module (CEM).

Check the fuse for the circuit.
Check the signal cable between engine control module (ECM) terminal #B17 (#C17) and the central electronic module (CEM). Check for a short-circuit to ground. Check for an open-circuit.
Remedy as necessary.

Other information
- For further information about the fuses and relays, see the Wiring Diagram
- Connecting the breakout box Connecting The Breakout Box, Engine Control Module (ECM)
- Checking wiring and terminals Checking Wiring And Terminals









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Read the position of the ignition key. Check that the ignition setting position is OFF when the ignition key is in position 2 (ignition on) and ON when the ignition key is in position 3 (start).
Check that the value read for the ignition key position is correct.





Is the value correct?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the component and wiring

-------------------------------------------------