Faulty Signal

Faulty signal

Checking the component and wiring
Check the cable between engine control module (ECM) terminal #B16 (#C16) and system relay terminal #2. Check for a short-circuit to supply voltage. Check for short-circuit to ground.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting The Breakout Box, Engine Control Module (ECM)
- For further information about the fuses and relays, see the Wiring Diagram
- Checking wiring and terminals Checking Wiring And Terminals









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
Check that the starter motor is running when the ignition switch is in position 3 (starting position).
Leave the ignition switched off for at least 10 minutes. Then check that the diagnostic trouble code (DTC) has not recurred.

Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the component and wiring

-------------------------------------------------