Part 3

Illustrations A and B




- Open the cover on the holder for the connectors. Use a screwdriver to release the catches.









- Open the grey 4-pin connector and connect the cable harness between these.
- Take a thick piece of foam tape from the kit. Wrap it around the "loose" connector and tear off the excess.
- Place the connector underneath the holder.
- Close the cover.





- Route the microphone cable (1) toward the centre console as illustrated.
- Route the cable harness (2) from the control module to the centre console as illustrated.
- Route the cable from the keypad (3) as illustrated.






Connect the connectors to the control module's cable harness:
1. adapter cable
2. microphone
3. keypad.





- Apply thin foam tape around the connectors and the excess cables and position them as illustrated.





- Take the yellow cable with cable lug from cable harness (B) and push it up by the gearshift.





- Route the cable as illustrated.

Note! Make sure that the cable does not lie by any of the gearshift's moving parts.





- Take the 10-pin green connector disconnected from the centre console. Open the catch.





- Connect the yellow cable to pin 9.
- Press the catch back.





- Take a tie strap from the kit and secure the cable to the existing cable harness.

Supplementary work





- Reinstall the upper section of the panel.





- Replace the connectors on the climate unit.

Note! Do not damage the fibre optic cables and other cables.





- Reinstall the edge clip with cable harness in the holder.





- Reinstall the edge clip with cable harness in the lower section of the centre console.





- Tighten the panel in using the existing screws.
- Reinstall the covers on the screws at the rear edge.





- Reinstall the panel for the media player.


Reinstall:
- gearshift's panel on the gaiter.
- panel in the centre console.
- Fold back the carpet.

Reinstall:
- side panel on the left and right-hand sides
- the sill trim panel
- the end face panel
- sound wall under the glove compartment.





- Download software (application) for the accessory's function.






Check the function as set out below:
- Turn the ignition key to position I.
- Turn on the radio.
- Check that the keypad for Bluetooth lights up.
- Press the button (1) in the middle of the control panel. The radio should mute and a voice should be heard.
- Press the button (2). The voice should stop and the radio sound should return.