Faulty Signal

Faulty signal

Checking the component
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can occur for a number of different reasons. The fault is evaluated depending on how it occurs.
Check the signal cable between control module terminal #A13 and the control module in the rear door terminal #6. Check for a short-circuit to ground.
Check the signal cable between control module terminal #A13 and the control module in the rear door terminal #6. Check for a short-circuit to supply voltage.
Replace the signal cable if a fault is found.
If no fault was found, replace the control module in the rear door.
Remedy as necessary.

Other information:
- Signal specification Signal Description, Driver's Door Module / Passenger Door Module (DDM/PDM)
- Checking wiring and terminals Checking Wiring And Terminals





Select the desired alternative.

Continue - Verification

-------------------------------------------------

Verification




Verification power window mechanism

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the power window mechanisms can be operated.

Does the control for the power window mechanism operate?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the component

-------------------------------------------------