Control System, Replacing

Control system, replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the cable harness
Remove the cable harness from the control system. See: Cable harness, control system, gearbox, replacing, B8444S, TF-80SC AWD Service and Repair.






Note! Protect the cable harness by taping it to the outside of the transmission.



















Installation

Note! For tightening torques, see: Tightening torque Mechanical Specifications.






Caution! Ensure that the cable harness is not trapped when the control system is positioned.





Lightly tighten.





Use new screws and a new gasket.
Lightly tighten.





Tighten alternately, M6.

Installing the cable harness
Install the cable harness for the control system. See: Cable harness, control system, gearbox, replacing, B8444S, TF-80SC AWD Service and Repair.