Faulty Signal

Faulty signal

Checking the sensor




- Ignition on.

Checking components and connectors
Check the connectors. Check for contact resistance. Check for oxidation. Check for loose connections.
Check the sensor in the seat. Take readings between:
- terminals #2 and #3 on connector B for the seat heating module (SHM). Check for an open-circuit
- terminal #2 on connector B and chassis ground. Check for a short-circuit to ground
- terminal #2 on connector B and terminal #4 on connector A. Check for a short-circuit to supply voltage.
Remedy as necessary.

Other information:
- For further information about the connectors, fuses and relays, see the relevant section in the Wiring Diagram
- Connecting the breakout box Connecting The Breakout Box, Climate Control Module (CCM)
- Signal specification Signal Specification
- Climate control, location of components Locations
- Seat heating module (SHM), replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals

Continue - Verification

-------------------------------------------------

Verification





Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Engine running.
Activate the seat heating. Check that the seat heats up.

Is the seat heater functioning?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking the sensor

-------------------------------------------------






Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the sensor

-------------------------------------------------