Removal and Replacement

E-pretensioner Unit Replacement

NOTE:

- Do not turn the ignition switch to ON (II) while the e-pretensioner unit connectors are disconnected.

- Do not remove the parking brake cable from the parking brake pedal.

1. Remove the accelerator pedal module. Service and Repair

2. Disconnect the connectors (A) from the e-pretensioner unit (B).

3. Remove the e-pretensioner unit from behind the heater unit.

4. Install the unit in the reverse order of removal.

5. After installing the e-pretensioner unit, make sure the SRS indicator comes on for about 6 seconds after turning the ignition switch to ON (II), then goes off.