Cowl Moulding / Trim: Service and Repair

Cowl Cover Replacement

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program

NOTE:

- Put on gloves to protect your hands.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

- Take care not to damage the body.

- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

1. Remove these items:
- Windshield wiper arms Service and Repair

- Front fender trim, both sides

2. Remove the cowl cover (A).
-1 Detach the clips (B).
Disconnect the washer tube (C).
-3 Detach the clips (D, E, F) by carefully pulling the cover up.
Release two front hooks (G) from the body.
-5 Release the hood hinge covers (H) from both hood hinges (I).

3. Install the cover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips and the hooks into place securely.

- Make sure the hood hinge covers are seated on the cowl cover securely.

- Make sure the washer tube is connected properly.