Driver's Dashboard Undercover Removal/Installation

Driver's Dashboard Undercover Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program

NOTE:
- Take care not to scratch the dashboard or the related parts.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the driver's dashboard lower cover. Driver's Dashboard Lower Cover Removal/Installation

2. Remove the driver's dashboard undercover (A).
-1 Gently pull down the rear edge to detach the clips.
Pull the undercover rearward to release its holder (B) from the pin (C).
-3 Disconnect the footwell light connector (D).

3. Install the undercover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips into place securely.

- Make sure the footwell light connector is plugged in properly.

- Make sure the holder of the undercover is installed securely to the pin.