Passenger's Dashboard Undercover Removal/Installation

Passenger's Dashboard Undercover Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program

NOTE:
- Take care not to scratch the dashboard or the related parts.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the passenger's dashboard undercover (A).
-1 Gently pull down the rear edge to detach the clips.
Pull the undercover away to release the pins (B) from the holders (C).
-3 Disconnect the footwell light connector (D) and the HFL control unit connector (E).

2. Install the undercover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips into place securely.

- Make sure each connector is plugged in properly.

- Make sure the pins of the undercover are installed securely to the holders.