Driveshaft Removal

Driveshaft Removal

Special Tools Required

- Ball joint threaded protector, 14 mm 07AAE-SJAA100
- Ball joint remover, 28 mm 07MAC-SL0A202

1. Raise the vehicle on a lift.

2. Remove the front wheels.

3. Pry up the stake (A) on the spindle nut (B), then remove the nut.

4. Drain the transmission fluid, then reinstall the drain plug with a new sealing washer:
- Manual transmission Service and Repair

- Automatic transmission ATF Replacement





5. Hold the stabilizer link joint pin (A) with a hex wrench (B), and remove the flange nut (C). Separate the front stabilizer link (D) from the lower arm.






6. Remove the damper fork mounting nut (A), the damper fork mounting bolt (B), and the damper pinch bolt (C), then remove the damper fork (D).






7. Remove the cotter pin (A) from the knuckle ball joint, and remove the castle nut (B). Separate the ball joint from the lower arm (C) using the 14 mm ball joint thread protector and the 28 mm ball joint remover. Ball Joint Removal
NOTE:

- Be careful not to damage the ball joint boot when installing the remover.

- Do not force or hammer on the lower arm, or pry between the lower arm and the knuckle. You could damage the ball joint.





8. Pull the knuckle outward, and separate the outboard joint from the front hub using a plastic hammer.






9. Left driveshaft: Pry the inboard joint (A) from the differential using a prybar. Remove the driveshaft as an assembly.
NOTE:

- Do not pull on the driveshaft (B), or the inboard joint may come apart. Pull the inboard joint straight out to avoid damaging the oil seal.

- Be careful not to damage the oil seal or the end of the inboard joint with the prybar.





10. Right driveshaft: Drive the inboard joint (A) off of the intermediate shaft using a drift and a hammer. Remove the driveshaft as an assembly.
NOTE:

- Do not pull on the driveshaft (B), or the inboard joint may come apart.

- Be careful not to damage the end of the inboard joint with the drift.





11. Remove the set ring (A) from the left driveshaft inboard joint.






12. Remove the set ring (A) from the intermediate shaft.