Operation CHARM: Car repair manuals for everyone.
Home >> Acura >> 2009 >> TSX L4-2.4L >> Repair and Diagnosis >> Transmission and Drivetrain >> Drive Axles, Bearings and Joints >> Axle Shaft Assembly >> Service and Repair >> Removal and Replacement >> Intermediate Shaft Installation

Intermediate Shaft Installation




Intermediate Shaft Installation

1. Clean the areas where the intermediate shaft contacts the differential thoroughly with solvent, and dry them with compressed air.
NOTE: Do not wash the rubber parts with solvent.

2. Install a new set ring (A) onto the set ring groove (B) of the intermediate shaft (C).

3. Insert the intermediate shaft into the differential correctly.
NOTE: Insert the intermediate shaft carefully to prevent damaging the oil seal (D).






4. Install the flange bolt (A) and the two dowel bolts (B).

5. Install the right driveshaft. Driveshaft Installation






6. M/T model: Install the CKP sensor cover (A) to the engine block.

7. Refill the transmission with the recommended transmission fluid:
- Manual transmission Service and Repair

- Automatic transmission ATF Replacement

8. Check the wheel alignment, and adjust it if necessary. Service and Repair

9. Test-drive the vehicle.





pro multis · About Operation CHARM