Passenger's Vent Panel Removal/Installation

Passenger's Vent Panel Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program; 888-424-6857

NOTE:

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

- Take care not to scratch the dashboard and related parts.

1. Remove these items.
- Center trim, both sides Dashboard Center Trim Removal/Installation

- Utility pocket housing Utility Pocket Housing Removal/Installation

- Instrument fascia Instrument Fascia Removal/Installation

- Audio unit Audio Unit Removal/Installation

2. Remove the passenger's vent panel (A).
-1 Open the glove box.
Gently pull out the panel to release the clips (B, C).
-3 Disconnect the hazard warning switch/passenger's airbag cutoff indicator connector (D).

3. Install the panel in the reverse order of removal, and note these items:
- Replace any damaged clips.

- If the clips are damaged or stress-whitened, replace them with new ones.

- Make sure the connector is plugged in properly.